How do I protect the pool shell during in-ground installation?
If the metal pool shell contacts backfill material, it must be covered with a heavy-duty bitumen waterproofing membrane to prevent corrosion.
What are the excavation requirements for an in-ground installation?
Excavate a hole 300mm wider than the pool’s dimensions, and accounting for the depth of the compacted road base or concrete slab. Ensure the ground beneath the pool has a minimum bearing capacity of 70 kPa.
What plumbing setup is required for in-ground installation?
Follow the OUTBACK Plumbing Diagram, adjusting pipework for proper alignment. Install a 15mm threaded PVC coupling and pipe to bing the drain plug to the surface. Run conduit for light cables and earthing tabs, which must be connected before backfilling.
Should the pool be filled before backfilling?
Yes, the pool should be completely filled and left for 24 hours to check for leaks before starting the backfilling process.
How do I manage groundwater for in-ground installation?
Install a 65mm continuous slotted AG pipe connected to a 100mm standpipe to monitor groundwater levels. Ensure groundwater does not exceed 500mm above the pool base. For sloping sites, use slotted AG pipes to redirect water away. Install a 15mm threaded PVC coupling and pipe to bing the drain plug to the surface.
How do I protect the pool shell from potential rusting issues?
Paint exposed metal areas with a heavy-duty bitumen waterproofing membrane. Ensure proper drainage around the pool by using a slope in the backfill material to direct water away from the shell. Consult the in ground install guide or engneering documentaion for specifics.
What backfill material should be used for in-ground installation?
The backfill material is a dry mix of cement-stabilised sand. Dpending on where this is sourced the ratio of sand to cement varies. Consult the in ground install guide or engneering documentaion for specifics.
Do you offer site inspections to determine the best placement for the pool?
While we don’t offer site inspections, we can provide guidance remotely based on photos or plans of your property. For complex installations, hiring a local builder, landscaper, or engineer is recommended for an on-site assessment.
What site preparation is required for underground plumbing and electrical connections?
The site should have clear and accessible trenches for plumbing and electrical connections. A licensed plumber and electrician are recommended for compliance and efficiency.
Are there any specific guidelines for pool fencing in my area?
Yes, all states and territories in Australia have specific guidelines for pool fencing, typically based on the Australian Standard AS1926.1-2012. It is essential to check with your local council or certifier for the exact requirements.